Results
Subscribe
Step-by-Step Solutions
University Majors
Support Hub
Legal & Support Articles
Contact Us
Login
Share
Results
Subscribe
Step-by-Step Solutions
University Majors
Support Hub
Legal & Support Articles
Contact Us
Login
Share
Chapter 1
Q. 1.P.28
Q. 1.P.28
How many nodes and branches does the following circuit have?
Step-by-Step
Verified Answer
The
'Blue Check Mark'
means that this solution was answered by an expert.
Learn more
on how do we answer questions.
Report Answer
Five nodes and seven branches.
Share
Share Answer
Related Answered Questions
Question: 1.SGPYQ.27
If, at t = 0^+ , the voltage across the coil is 120 V, the value of resistance R is (a) 0 Ω (b) 20 Ω (c) 40 Ω (d) 60 Ω ...
Question: 1.SGPYQ.28
For the value of obtained in the above question, the time taken for 95% of the stored energy to be dissipated is close to (a) 0.10 s (b) 0.15 s (c) 0.50 s (d) 1.0 s ...
Question: 1.SGPYQ.26
In the given figure, the Thevenin’s equivalent pair (voltage and impedance), as seen at the terminals P-Q, is given by (a) 2 V, 5 Ω (b) 2 V, 7.5 Ω (c) 4 V, 5 Ω (d) 4 V, 7.5 Ω ...
Question: 1.SGPYQ.1
Figure given below shows the waveform of the current passing through an inductor of resistance 1 Ω and inductance 2 H. The energy absorbed by the inductor in the first four seconds is (a) 144 J (b) 98 J (c) 132 J (d) 168 J ...
Question: 1.SGPYQ.2
A segment of a circuit is shown in the figure given below. vR = 5 V, vC = 4sin2t. The voltage vL is given by (a) 3 – 8cos2t (b) 32sin2t (c) 16sin2t (d) 16cos2t ...
Question: 1.SGPYQ.3
In the figure given below, Z1 = 10∠−60°, Z2 = 10∠60°, Z3 = 50 ∠53.13°. Thevenin impedance seen from X-Y is (a) 56.6∠45° (b) 60∠30° (c) 70∠30° (d) 34.4∠65° ...
Question: 1.SGPYQ.4
In the circuit of figure given below, the magnitudes of VL and VC are twice that of VR. The inductance of the coil is (a) 2.14 mH (b) 5.30 H (c) 31.8 mH (d) 1.32 H ...
Question: 1.SGPYQ.5
In the figure given below, the potential difference between points P and Q is (a) 12 V (b) 10 V (c) -6 V (d) 8 V ...
Question: 1.SGPYQ.6
Two AC sources feed a common variable resistive load as shown in the figure given below. Under the maximum power transfer condition, the power absorbed by the load resistance RL is (a) 2200 W (b) 1250 W (c) 1000 W (d) 625 W ...
Question: 1.SGPYQ.7
In the given figure, the value of R is (a) 10 Ω (b) 18 Ω (c) 24 Ω (d) 12 Ω ...