Holooly Plus Logo
Holooly Plus Logo

Question 8.Q.1: Refer to Figure 8.3. 1 Resistor R1 is changed to 1 kΩ. Calcu...

Refer to Figure 8.3.

1 Resistor R_{1} is changed to 1 kΩ. Calculate the new values of UTP, LTP and the hysteresis.

8.3
The blue check mark means that this solution has been answered and checked by an expert. This guarantees that the final answer is accurate.
Learn more on how we answer questions.

1 +1.18 V, -1.18 V, 2.36 V

Related Answered Questions

Question: 8.PE.1

To investigate the Schmitt trigger using (a) the 741 operational amplifier ic, (b) the 7414 Schmitt trigger ic For this exercise you will need the following components and equipment: 1 – 741 ic (operational amplifier) 1 – 74LS14 ic (hex inverting Schmitt trigger) (six Schmitt triggers in one ...

Verified Answer:

Procedure (a): using the 741 operational amplifier...
Question: 8.Q.3

Refer to Figure 8.3. 3 For a fixed value of R2 how does the hysteresis depend upon the value of R1? ...

Verified Answer:

3 R_{1} decreases, hysteresis decre...
Question: 8.Q.2

Refer to Figure 8.3. 2 A hysteresis value of 2 V is required. Calculate suitable values for R1 and R2. ...

Verified Answer:

2 R_2=12 \ k \Omega, R_1=1 \ k\Omega[/latex...
Question: 8.PE.2

To investigate the astable multivibrator using (a) the 741 operational amplifier ic, (b) the 555 timer ic, (c) the 7414 Schmitt trigger ic For this exercise you will need the following components and equipment: 1 – 741 ic (operational amplifier) 1 – 555 ic (timer) 1 – 74LS14 ic (hex inverting ...

Verified Answer:

Procedure (a): using the 741 operational amplifier...
Question: 8.PE.3

To investigate the monostable multivibrator using (a) the 555 timer ic, (b) the 74121 monostable ic For this exercise you will need the following components and equipment: 1 – 555 ic (timer) 1 – 74121 ic (monostable multivibrator) 1 – +5 V dc supply 1 – set of components for the 555 timer circuit: ...

Verified Answer:

Procedure (a) 1 Connect up the circuit of Figure 8...
Question: 8.Q.8

By what practical method could a variable mark-space ratio output be provided? ...

Verified Answer:

(a) Connect pin 5 to variable dc supply (b) Connec...
Question: 8.Q.7

What would be the effect (if any) on the frequency, of having a supply voltage greater than 5 V ? ...

Verified Answer:

Lower frequency
Question: 8.Q.6

Why can the mark-space ratio never be less than 1:1? ...

Verified Answer:

(R_1+ R_2) can never...
Question: 8.Q.5

What would be the effect on the mark-space ratio of making R2 much larger than R1 (say, R1 = 1 kΩ and R2 = 10 kΩ)? ...

Verified Answer:

Mark-space ratio becomes 1:1