Holooly Plus Logo
Holooly Plus Logo

Question 11.25: Show the design of an 8031-based system with 8K bytes of pro...

Show the design of an 8031-based system with 8K bytes of program ROM and 8K bytes of data ROM.

The blue check mark means that this solution has been answered and checked by an expert. This guarantees that the final answer is accurate.
Learn more on how we answer questions.

Figure 14-14 shows the design. Notice the role of PSEN and RD in each ROM. For program ROM, PSEN is used to activate both OE and CE. For data ROM, we use RD to active OE, while CE is activated by a Simple decoder.

888

Related Answered Questions

Question: 11.8

Write a program in which the 8051 reads data from P1 and writes it to P2 continuously while giving a copy of it to the serial COM port to be transferred serially. Assume that XTAL=11.0592. Set the baud rate at 9600. ...

Verified Answer:

  ORG       0000H LJMP     MAIN ORG      ...
Question: 11.22

Looking at the design in Figure 14-6, find the address range for the Following. (a) Y4, (b) Y2, and (c) Y7. ...

Verified Answer:

(a) The address range for Y4 is calculated as foll...
Question: 11.5

Assume that the INT1 pin is connected to a switch that is normally high. Whenever it goes low, it should turn on an LED. The LED is connected to P1.3 and is normally off. When it is turned on it should stay on for a fraction of a second. As long as the switch is pressed low, the LED should stay on. ...

Verified Answer:

ORG    0000H LJMP   MAIN            ;by-pass inter...
Question: 11.28

In a certain application, we need 256K bytes of NV-RAM to store data collected by an 8051 microcontroller. (a) Show the connection of an 8051 to a single 256K×8 NV-RAM chip. (b) Show how various blocks of this single chip are accessed ...

Verified Answer:

(a) The 256K×8 NV-RAM has 18 addres...
Question: 11.27

Assume that we need an 8031 system with 16KB of program space, 16KB of data ROM starting at 0000, and 16K of NV-RAM starting at 8000H. Show the design using a 74LS138 for the address decoder. ...

Verified Answer:

The solution is diagrammed in Figure 14-17. Notice...
Question: 11.26

(a) Write a program to read 200 bytes of data from P1 and save the data in external RAM starting at RAM location 5000H. (b) What is the address space allocated to data RAM in Figure 14-15? ...

Verified Answer:

(a) RAMDATA   EQU   5000H COUNT        EQU    200 ...
Question: 11.24

An external ROM uses the 8051 data space to store the look-up table (starting at 1000H) for DAC data. Write a program to read 30 Bytes of these data and send it to P1. ...

Verified Answer:

MYXDATA    EQU   1000H COUNT         EQU   30   … ...
Question: 11.23

Discuss the program ROM space allocation for each of the following cases. (a) EA = 0 for the 8751 (89C51) chip. (b) EA = Vcc with both on-chip and off-chip ROM for the 8751. (c) EA = Vcc with both on-chip and off-chip ROM for the 8752. ...

Verified Answer:

(a) When EA = 0, the EA pin is strapped to GND, an...
Question: 11.21

Discuss the number of pins set aside for address in each of the following memory chips. (a) 16K×4 DRAM (b) 16K×4 SRAM ...

Verified Answer:

Since 2^{14} = 16K (a) For DRAM we ...
Question: 11.20

For ROM chip 27128, find the number of data and address pins. ...

Verified Answer:

The 27128 has a capacity of 128K bits. It has 16K ...