Question 3.37: Design a circuit that shifts up the dc level of a signal by ......

Fundamentals of Microelectronics [1244192]

Design a circuit that shifts up the dc level of a signal by $2V_{D,on}$ .

Step-by-Step

The 'Blue Check Mark' means that this solution was answered by an expert.
Learn more on how do we answer questions.

To shift the level up, we apply the input to the cathode. Also, to obtain a shift of $2V_{D,on}$ , we place two diodes in series. Figure 3.60 shows the result.

3.60

Related Answered Questions

Question: 3.38

Recall from Chapter 2 that diodes exhibit a junction capacitance in reverse bias. Study the effect of this capacitance on the operation of the above circuit. ...

Verified Answer:

Figure 3.62 shows the equivalent circuit for the c...

Question: 3.36

Sketch the current through D1 in the doubler circuit as function of time. ...

Verified Answer:

Using the diagram in Fig. 3.58(a), noting that [la...

Question: 3.35

Plot the output waveform of the circuit shown in Fig. 3.56 if the initial condition across C1 is zero. ...

Verified Answer:

As

V_{in}

rises from zero, attempti...

Question: 3.34

A signal must be limited at ±100 mV. Assuming VD,on = 800 mV, design the required limiting circuit. ...

Verified Answer:

Figure 3.52(a) illustrates how the voltage sources...

Question: 3.33

In the circuit of Fig. 3.45(a), Vin has a nominal value of 5 V, R1 = 100 Ω , and D2 has a reverse breakdown of 2.7 V and a small-signal resistance of 5 Ω. Assuming VD,on ≈ 0.8 V for D1, determine the line and load regulation of the circuit. ...

Verified Answer:

We first determine the bias current of

D_{1...

Question: 3.32

A radio frequency signal received and amplified by a cellphone exhibits a peak swing of 10 mV. We wish to generate a dc voltage representing the signal amplitude [Eq. (3.8)]. Is it possible to use the half-wave or full-wave rectifiers studied above? ...

Verified Answer:

No, it is not. Owing to its small amplitude, the s...

Question: 3.31

Design a full-wave rectifier to deliver an average power of 2 W to a cellphone with a voltage of 3.6 V and a ripple of 0.2 V ...

Verified Answer:

We begin with the required input swing. Since the ...

Question: 3.30

Plot the currents carried by each diode in a bridge rectifier as a function of time for a sinusoidal input. Assume no smoothing capacitor is connected to the output. ...

Verified Answer:

From Figs. 3.38(c) and (d), we have

V_{out}...

Question: 3.29

Assuming a constant-voltage model for the diodes, plot the input/output characteristic of a full-wave rectifier. ...

Verified Answer:

The output remains equal to zero for |

V_{in...

Question: 3.28

Determine the peak diode current in Example 3.27 assuming VD,on ≈ 0 and C1 = 1.417 F. ...

Verified Answer:

We have

V_{p}

= 4.5 V,

R_{L}...