Question 6.8: For a single-channel PCM system with a sample rate fs = 6000......

Advanced Electronic Communications Systems [1093752]

For a single-channel PCM system with a sample rate $f_{s}$ = 6000 samples per second and a seven-bit compressed PCM code, determine the line speed:

Step-by-Step

The 'Blue Check Mark' means that this solution was answered by an expert.
Learn more on how do we answer questions.

line speed = $\frac{6000\, samples}{second}×\frac{7\,bits}{sample}$

= 42,000 bps

Related Answered Questions

Question: 6.6

Determine the 12-bit linear code, the eight-bit compressed code, the decoded 12-bit code, the quantization error, and the compression error for a resolution of 0.01 V and analog sample voltages of (a) +0.053 V, (b) −0.318 V, and (c) +10.234 V ...

Verified Answer:

a. To determine the 12-bit linear code, simply div...

Question: 6.5

For a compressor with a μ = 255, determine a. The voltage gain for the following relative values of Vin: Vmax, 0.75 Vmax, 0.5 Vmax, and 0.25 Vmax. b. The compressed output voltage for a maximum input voltage of 4 V. c. Input and output dynamic ranges and compression. ...

Verified Answer:

a. Substituting into Equation 10, the following v...

Question: 6.4

For a PCM system with the following parameters, determine (a) minimum sample rate, (b) minimum number of bits used in the PCM code, (c) resolution, and (d) quantization error. Maximum analog input frequency = 4 kHz Maximum decoded voltage at the receiver = ±2.55 V Minimum dynamic range = 46 dB ...

Verified Answer:

a. Substituting into Equation 1, the minimum samp...

Question: 6.3

For the PCM coding scheme shown in Figure 8, determine the quantized voltage, quantization error (Qe), and PCM code for the analog sample voltage of +1.07 V. ...

Verified Answer:

To determine the quantized level, simply divide th...

Question: 6.1

For the sample-and-hold circuit shown in Figure 5a, determine the largest-value capacitor that can be used. Use an output impedance for Z1 of 10 Ω, an on resistance for Q1 of 10 Ω, an acquisition time of 10 μs, a maximum peak-to-peak input voltage of 10 V, a maximum output current from Z1 of 10 mA, ...

Verified Answer:

The expression for the current through a capacitor...

Question: 6.2

For a PCM system with a maximum audio input frequency of 4 kHz, determine the minimum sample rate and the alias frequency produced if a 5-kHz audio signal were allowed to enter the sample-and hold circuit. ...

Verified Answer:

Using Nyquist’s sampling theorem (Equation 1), we ...