Holooly Plus Logo
Holooly Plus Logo

Question 1.P.36: Formulate the cut-set matrix for the directed graph shown be......

Formulate the cut-set matrix for the directed graph shown below.

1.36
Step-by-Step
The 'Blue Check Mark' means that this solution was answered by an expert.
Learn more on how do we answer questions.
Report Answer

The tree and cut set corresponding to the graph are shown as follows.

 

Branches
Twigs Links
6 5 4 3 2 1 Cut set
0 0 1 0 1 -1 ①
0 1 0 -1 -1 0 ②
1 0 0 -1 0 -1 ③
1.36.1

Related Answered Questions

Question: 1.SGPYQ.27

If, at t = 0^+ , the voltage across the coil is 120 V, the value of resistance R is (a) 0 Ω (b) 20 Ω (c) 40 Ω (d) 60 Ω ...

Verified Answer:

i_{ L }\left(0^{-}\right)=\frac{\text { To...
Question: 1.SGPYQ.28

For the value of obtained in the above question, the time taken for 95% of the stored energy to be dissipated is close to (a) 0.10 s (b) 0.15 s (c) 0.50 s (d) 1.0 s ...

Verified Answer:

E_1 is the stored energy and [lat...
Question: 1.SGPYQ.26

In the given figure, the Thevenin’s equivalent pair (voltage and impedance), as seen at the terminals P-Q, is given by (a) 2 V, 5 Ω (b) 2 V, 7.5 Ω (c) 4 V, 5 Ω (d) 4 V, 7.5 Ω ...

Verified Answer:

To find the Thevenin voltage open circuit the term...
Question: 1.SGPYQ.1

Figure given below shows the waveform of the current passing through an inductor of resistance 1 Ω and inductance 2 H. The energy absorbed by the inductor in the first four seconds is (a) 144 J (b) 98 J (c) 132 J (d) 168 J ...

Verified Answer:

Power is the rate of change of energy. Therefore, ...
Question: 1.SGPYQ.2

A segment of a circuit is shown in the figure given below. vR = 5 V, vC = 4sin2t. The voltage vL is given by (a) 3 – 8cos2t (b) 32sin2t (c) 16sin2t (d) 16cos2t ...

Verified Answer:

Applying Kirchhoff’s current law, sum of incoming ...
Question: 1.SGPYQ.3

In the figure given below, Z1  = 10∠−60°, Z2 = 10∠60°, Z3 = 50 ∠53.13°. Thevenin impedance seen from X-Y is (a) 56.6∠45° (b) 60∠30° (c) 70∠30° (d) 34.4∠65° ...

Verified Answer:

Given that Z_1=10 \angle-60^{\circ}, Z_2=1...
Question: 1.SGPYQ.4

In the circuit of figure given below, the magnitudes of VL and VC are twice that of VR. The inductance of the coil is (a) 2.14 mH (b) 5.30 H (c) 31.8 mH (d) 1.32 H ...

Verified Answer:

Given that for resonance \left|V_{ L }\rig...
Question: 1.SGPYQ.5

In the figure given below, the potential difference between points P and Q is (a) 12 V (b) 10 V (c) -6 V (d) 8 V ...

Verified Answer:

At node P, \begin{aligned} & 2+\frac{V...
Question: 1.SGPYQ.6

Two AC sources feed a common variable resistive load as shown in the figure given below. Under the maximum power transfer condition, the power absorbed by the load resistance RL is (a) 2200 W (b) 1250 W (c) 1000 W (d) 625 W ...

Verified Answer:

For maximum power transfer, R_{ L }=\left|...
Question: 1.SGPYQ.7

In the given figure, the value of R is (a) 10 Ω (b) 18 Ω (c) 24 Ω (d) 12 Ω ...

Verified Answer:

The equivalent circuit is Applying nodal analysis ...