Question 2.SP.17: In the positive clipping circuit of Fig. 2-17(a), the diode ......

Schaum’s Outline of Electronic Devices and Circuits [1089587]

In the positive clipping circuit of Fig. 2-17(a), the diode is ideal and $v_i$ is a 10-V triangular wave with period $T$ . Sketch one cycle of the output voltage $v_o$ if $V_b = 6 \text{V}$ .

2.17

Step-by-Step

The 'Blue Check Mark' means that this solution was answered by an expert.
Learn more on how do we answer questions.

The diode blocks (acts as an open circuit) for $v_i < 6 \text{V}$ , giving $v_o = v_i$ . For $v_i ≥ 6 \text{V}$ , the diode is in forward conduction, clipping $v_i$ to effect $v_o = 6 \text{V}$ . The resulting output voltage waveform is sketched in Fig. 2-33.

2.33

Related Answered Questions

Question: 2.2

Find the value of VT in (2.1) at 20°C. ...

Verified Answer:

Recalling that absolute zero is -273°C, we write [...

Question: 2.13

Calculate the ripple factor for the half-wave rectifier of Example 2.10 (a) without a filter and (b) with a shunt capacitor filter as in Fig. 2-15(a). ...

Verified Answer:

(a) For the circuit of Example 2.10,

F_r =...

Question: 2.SP.26

Using ideal diodes, resistors, and batteries, synthesize a function-generator circuit that will yield the i-v characteristic of Fig. 2-41(a). ...

Verified Answer:

Since the

i-v

characteristic has tw...

Question: 2.SP.18

Draw a transfer characteristic relating vo to vi for the positive clipping network of Problem 2.17. Also, sketch one cycle of the output waveform if vi = 10 sin ωt V. ...

Verified Answer:

The diode blocks for

v_i < 6 \text{V}[/...

Question: 2.SP.16

Size the filter capacitor in the rectifier circuit of Fig. 2-15(a) so that the ripple voltage is approximately 5 percent of the average value of the output voltage. The diode is ideal, RL = 1 kΩ, and vS = 90 sin 2000t V. Calculate the average value of vL for this filter. ...

Verified Answer:

With

F_r = 0.05

, (2.10) gives [late...

Question: 2.SP.15

The circuit of Fig. 2-32 adds a dc level (a bias voltage) to a signal whose average value is zero. If vS is a 10-V square wave of period T, RL = R1 = 10 Ω, and the diode is ideal, find the average value of vL. ...

Verified Answer:

For

v_L > 0, D

is forward-biase...

Question: 2.SP.14

The circuit of Fig. 2-22(a) is to be used as a dc power supply for a load RL that varies from 10 Ω to 1 kΩ; vS is a 10-V square wave. Find the percentage change in the average value of vL over the range of load variation, and comment on the quality of regulation exhibited by this circuit. ...

Verified Answer:

Let

T

denote the period of

v...

Question: 2.SP.13

The circuit of Fig. 2-31(a) is an ‘‘inexpensive’’ voltage regulator; all the diodes are identical and have the characteristic of Fig. 2-26(b). Find the regulation of vo when Vb increases from its nominal value of 4 V to the value 6 V. Take R = 2 kΩ. ...

Verified Answer:

We determined in Problem 2.7 that each diode can b...

Question: 2.SP.24

Sketch the i-v input characteristic of the network of Fig. 2-39(a) when (a) the switch is open and (b) the switch is closed. ...

Verified Answer:

The solution is more easily found if the current s...

Question: 2.SP.25

In the small-signal circuit of Fig. 2-40, the capacitor models the diode diffusion capacitance, so that C = Cd = 0.02 μF, and vth is known to be of frequency ω = 10^7 rad/s. Also, rd = 2.5 Ω and ZTh = RTh = 10 Ω. Find the phase angle (a) between id and vd and (b) between vd and vth. ...

Verified Answer:

(a) The diffusion capacitance produces a reactan...