Question 18.12: (a) Determine the bandwidth and center frequency for the fil...

Electronics Fundamentals Circuits, Devices and Applications

(a) Determine the bandwidth and center frequency for the filter in Figure 43.

(b) Draw the response curve.

fig18,43

The "Step-by-Step Explanation" refers to a detailed and sequential breakdown of the solution or reasoning behind the answer. This comprehensive explanation walks through each step of the answer, offering you clarity and understanding.
Our explanations are based on the best information we have, but they may not always be right or fit every situation.

The blue check mark means that this solution has been answered and checked by an expert. This guarantees that the final answer is accurate.
Learn more on how we answer questions.

This Question has been Answered.

Already have an account?

Related Answered Questions

Question: 18.6

Figure 16 shows a practical integrator using a feedback resistor to prevent the op-amp from saturating due to small imbalances in the capacitor charging and discharging current. The feedback resistor has only a small effect on the circuit and is selected to have about 7% of the charging current, ...

Verified Answer:

(a)

\frac{\Delta V_{out}}{\Delta t} = − \f...

Question: 18.10

Calculate the capacitance values required to produce a 3 kHz critical frequency in the low-pass filter of Figure 36. ...

Verified Answer:

The resistor values have already been set at 22 kΩ...

Question: 18.11

For the filter of Figure 41, calculate the resistance values required to produce a critical frequency of 5.5 kHz. ...

Verified Answer:

The capacitor values have been preselected to be 0...

Question: 18.7

Figure 20 shows a practical differentiator circuit with a series resistor on the input to limit high-frequency gain (reducing noise and ringing). This resistor has a negligible effect on the general circuit operation. The input waveform is taken from the output of the integrator in Example 6. ...

Verified Answer:

The time constant is

R_{f}C = (10 kΩ)(2.2 ...

Question: 18.14

In Figure 56, what power rating must R1 have if the maximum input voltage is 12.5 V? ...

Verified Answer:

The worst-case power dissipation in

R_{1}[/...

Question: 18.13

Determine the output voltage for the regulator in Figure 51. ...

Verified Answer:

V_{REF} = 5.1  V

, the zener voltage...

Question: 18.9

Determine the frequency of the circuit in Figure 30. What is the frequency if R1 is changed to 20 kΩ? ...

Verified Answer:

f = \frac{1}{4R_{1}C}\left( \frac{R_{2}}{R_...

Question: 18.8

Determine the frequency of oscillation for the JFET stabilized Wien-bridge oscillator in Figure 27. ...

Verified Answer:

For the lead-lag circuit,

R_{1} = R_{2} = R...

Question: 18.5

For the scaling adder in Figure 11, determine the weight of each input voltage and find the output voltage. ...

Verified Answer:

Weight of input 1:

\frac{R_{f}}{R_{1}} = \f...

Question: 18.4

Show that the amplifier in Figure 10 produces an output whose magnitude is the average of the input voltages. ...

Verified Answer:

Since the input resistors are equal, R = 100 kΩ. T...