Holooly Plus Logo
Holooly Plus Logo

Question 4.8: Find the incremental coordinates of the working points shown...

Find the incremental coordinates of the working points shown in Fig. 4.101a.

4.101
The blue check mark means that this solution has been answered and checked by an expert. This guarantees that the final answer is accurate.
Learn more on how we answer questions.

The incremental coordinates of a new working point are measured from an existing point one by one in sequence. Taking an example of A, its  incremental coordinates (−2.0,−1.0) are measured from origin O; similarly, other working points B, C, D, E, and F are measured from A, B, C, D, and E as shown in Fig. 4.102b, respectively.

4.102

Related Answered Questions

Question: 4.10

Write the G-code for the motion control of the milling operation on the part shown in Fig. 4.108a. ...

Verified Answer:

The milling operation is to create the profile of ...
Question: 4.9

Use APT to write a NC program to mill the part shown in Fig. 4.104 ...

Verified Answer:

By using APT, the NC program is written and shown ...
Question: 4.7

Determine the absolute coordinates of working points shown in Fig. 4.99a. ...

Verified Answer:

The absolute coordinates are measured from origin ...
Question: 4.6

Figure 4.88 shows a fixture setup for the milling operation on the part for a slot feature. The fixturing system is implemented by using the 3–2 principle. The primary plane makes the contacts to the bottom surface of the part. The movements along x-axis and y-axis are constrained by one and two ...

Verified Answer:

Based on the provided information, the workpiece a...
Question: 4.5

Figure 4.41a shows the dimensions of a machined part. Use the AutoDimensionScheme tool tin DimXpert o annotate GD&T information automatically. ...

Verified Answer:

Firstly, the part is modeled based on the dimensio...
Question: 4.4

Use Table 4.5 to determine the tolerances of hole and shaft fit with RC8 for a basic size of 0.50. ...

Verified Answer:

Firstly, the basic size is used to locate the roww...
Question: 4.3

Determine the fit types of shafts and holes in Table 4.3. ...

Verified Answer:

Equation (4.10) is used to evaluate the maximum an...
Question: 4.2

Determine the dimensioning schematic to obtain a better accuracy of the dimension A2A5 in Fig. 4.33. ...

Verified Answer:

For the baseline dimensioning in Fig. 4.33a, the d...
Question: 4.1

In the spider lift shown in Fig. 4.17a, a few of the highlighted components are made of composite materials. These components are adopted to avoid a direct circuit flow from a power line to ground. The parts are prototyped and tested in the real-world application environment. However, a failure ...

Verified Answer:

The Solidwork Simulation is used to analyze a comp...