Holooly Plus Logo
Holooly Plus Logo

Question 13.3: Use the data from Prob. 6.12 and Fig. 6.13. To prevent lique...

Use the data from Prob. 6.12 and Fig. 6.13. To prevent liquefaction-induced settlement of the building, what is the minimum length of piles that should be installed at the site?

6.13
The blue check mark means that this solution has been answered and checked by an expert. This guarantees that the final answer is accurate.
Learn more on how we answer questions.

Soil will liquefy down to a depth of about 20 m. Thus the piles should be at least 20 m long.

Related Answered Questions

Question: 13.2

Use the data from Prob. 13.1 and an effective friction angle Φ’ between the pile surface and the surface soil layer and sand layer of 28°. Assume that k0 = 0.5 and that the last location for the earthquake-induced pore water pressures to dissipate will be just above the clayey fine sand layer. ...

Verified Answer:

Divide the soil into two layers, as follows: Layer...
Question: 13.1

Use the data from Prob. 9.11 and Fig. 9.38 and assume a level-ground site. A proposed building will have a deep foundation system consisting of piles that are driven into the Flysh claystone. Assuming that the piles are widely spaced and do not increase the liquefaction resistance of the soil, ...

Verified Answer:

See page E.80. Depth, m Figure 7.1 Figure 7.2 ...