Question 7.7: Calculate normal electrostatic force exerted on a 1 mm × 1 m...

Introduction to Mechatronics

Calculate normal electrostatic force exerted on a 1 mm × 1 mm plate of $ε_r$ = 1.0 for air dielectric and $ε_0$ = 8.85 pF/m or $8.85 × 10^{–12}$ C²/N m² for material.

The "Step-by-Step Explanation" refers to a detailed and sequential breakdown of the solution or reasoning behind the answer. This comprehensive explanation walks through each step of the answer, offering you clarity and understanding.
Our explanations are based on the best information we have, but they may not always be right or fit every situation.

The blue check mark means that this solution has been answered and checked by an expert. This guarantees that the final answer is accurate.
Learn more on how we answer questions.

This Question has been Answered.

Already have an account?

Related Answered Questions

Question: 7.6

A differential cylinder is on one side of the piston area A = 10 cm² and the annular piston surface area on other side is Ap = 5 cm². The stroke length s is 10 cm. The pump delivers 10 L/min and the maximum pressure is 100 bar. Determine the speed of advance (pitch) and return stroke. Determine ...

Verified Answer:

Velocity during advance =

\frac{Q}{A} =\fra...

Question: 7.5

Ingredients are fed continuously to a paint-drying furnace by a conveyor. To minimize heat loss through the furnace door, it should be opened only for the duration of time necessary to allow the ingredients to pass through. The hydraulic circuit should be designed so that the door can be safely ...

Verified Answer:

Install a de-lockable non-return valve into the su...

Question: 7.4

A stepper motor is to be used to drive a linear axis of a mechatronic system. The motor output shaft is connected to a screw thread with a 30 mm pitch. It is desired to control each axis at 0.5 mm. What is the corresponding step angle? ...

Verified Answer:

Pitch of the screw thread, p = 30 mm Linear resolu...

Question: 7.3

A motor has torque constant Kt = 100 Nm A and voltage constant of 12 V(/kilo revolution/min). The armature resistance is 2 Ω. If 24 V voltage is applied to the terminal, what would be (a) the torque at the rotor (b) speed at zero load, and (c) torque at 100 revolution/min. Plot the result as a ...

Verified Answer:

At zero RPM, the back emf developed

V_B = 0...

Question: 7.2

A hydraulic rotor actuator is used for a twist joint with a hydraulic power source of pressure 70 bars and flow rate 2 m³/min. The outer and inner radii of the vane are 65 mm and 20 mm, respectively. The thickness of the vane is 0.5 mm. Determine the angular velocity and torque that can be ...

Verified Answer:

Supply pressure

P_s

= 70 bar Fluid ...

Question: 7.1

What are the holding force and velocity of the movement of piston of a single acting hydraulic actuator when the fluid pressure is 100 bar, the diameter of the piston is 50 mm, and the flow rate is 0.3 m³/min? ...

Verified Answer:

Supply pressure

P_s

= 100 bar Area ...